If you do strip the screw, you may still be able to remove it using a 1 mm flat screwdriver. selina - 09/06/2012 Beware, watch the video, there is a antenna cover/clip that pops out easily when you remove the inside screw and has to be replaced. Replacing the antenna connector is a tad fiddly but, with a little patience, easily resolved. Now it does not hold a charge for more than 4 hours. Source
I read over 50-60 posts on this subject, and the proven fix has always been the same. Also write numbers on the pictures next the screws to indicate the order in which you removed them. This requires you call apple or chat apple to discuss what the remote diagnostic test sent. Reply 12-19-2014,02:28 PM #3 Bivolarudk iMore Nanite Posts 4 Posts Re: How do I fix CRC error in the log? imp source
Vielen Dank! Before reconnecting the battery connector, be sure the contact clip (shown in red) is properly positioned next to the battery connector. Most Liked Posts hatrickpatrick, Jun 18, 2014 hatrickpatrick macrumors newbie Joined: May 25, 2008 #1 Background: A while ago I noticed that my iPhone was crashing a lot.
Hey! When I googled the message it told me that it was a hardware problem. Is there a store or location I can take my iphone to have (pay) a professional replace the battery for me? the adhesive on the battery tends to be under the edge of the battery nearest the center of the phone.
Appreciate any insight. greatnewshere - 11/13/2015 Reply All worked as explained. cause it is easier to remove without the logic board being there Winnie Lee - 12/12/2014 Adhesive was holding battery VERY firmly, so during this step I used a hair blow http://forums.macrumors.com/threads/what-specifically-causes-a-stuck-battery-indicator.1746318/ msaravanamsk - 10/07/2015 Reply Three iPhone 4, (two 32GB and one 8GB) have their new life starting today :) thank you iFixit.com Therm - 11/11/2015 Reply Thanks for all the tips
I clicked the clip into the socket first and then was very careful to fold the excess while putting the battery back in so the ribbon cable didn't kink. Ugh!! I'm very pleased. 1 Photo Comment Post Cancel VirtualLife Junior Member Join Date: Mar 2016 Posts: 107 #22 08-20-2016, 08:06 PM Thanks for the pic. On an iPhone 4S iOS 6.1.3 Hide Question All replies Helpful answers by diesel vdub, diesel vdub Sep 8, 2013 2:32 PM in response to Gustavo Gomez Level 7 (22,037 points)
i forgot to tell you that in my country there isn´t an Apple Store, so i could not go and exchange it for other The iPhone has 2 years of use... I've had a look in iPhone Configuration Utility and found the following, endlessly cycling error loop whenever the phone is plugged in: Quote Jul 9 14:02:54 Paddys-New-iPhone CLTM
superkep - 05/14/2013 Reply This is a great guide! this contact form Thanks. If I find any solution I will let you know. I thought it may be the antenna checked online saw how to check this and opened the phone up (not under warrenty anyway) and pulled the antenna off and put it
Shoung0690 - 10/20/2011 Reply My battery was so firmly glued in, it took a long time to slowly pry it loose. By iMore.com in forum iMore.com News Discussion Replies: 0 Last Post: 12-19-2014, 12:51 PM Why can't I click open a link sent to me in my messages? Battery was completely dead when I put it in, so I retried my old one to make sure I didn't mess up the install, then reinstalled the new one. http://digitalezines.com/crc-errors/crc-errors-dsl.html One was easy and other refuses to budge.
diagnostics says its rebooting from a "WDT Timeout" But I am stumped as to what component inside needs to be checked to troubleshoot this more. 12/21/2013 by jkerman the same problem All rights reserved. Yoda - October 27 Reply Add Comment 1024 Embed this guide Choose a size and copy the code below to embed this guide as a small widget on your site /
Escalated through reboot, recovery, restores all the way to complete new and minimal installation. So I started thinking that could be the issue, and covered the metal bracket in electrical tape before screwing it back on. i Googled and didn't find anything so i came here! Live blog 2016 Mac Event Live Blog It's Apple Financial Call Time!
No prblems with relacing battery. okhoosier - 02/07/2013 Reply From the tools list it seems as though the 00 driver is the one needed for the battery connector screw and the 000 is only needed if Mighty fiddly to work on. Check This Out Keep SIM card.
During reassembly, we recommend you replace the 5-point screws with equivalent Phillips screws. Today's Posts Popular This Week Ask a Question Advanced Search Titles Only OR Settings Subscribed Threads Edit Avatar Edit Profile General Settings Friends & Contacts My Profile Mark Forums Read 0 How to fix some mysterious problems.HELP Iphone 3gs Losing signal as well as CRC ERRoRs 0 I have a wierd problem with my Iphone 3gs its on 6.1 firmware This can cause memory pile ups and error messages to appear on your operating system.
Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? On an iPhone 4S iOS 6.1.3 My iPhone 4S keeps shutting off by itself.